Junorev is a 100% acrylic smooth masonry coating of the highest quality with anti-mould preservatives and anti-carbonation properties.
Junorev provides excellent performance and adhesion properties on tough exterior surfaces.
This product is CE certified for transmission of liquid water and permeability of water vapours, adhesion, light stability and anti-carbonation.
Indoor or outdoor use.
Dilutes and cleans with water.
EPD certified (Environmental Product Declaration): allows for sustainable building according to LEED and BREEAM standards.
15 / 4 litres
JUNOREV Smooth
UNTREATED (NEW) SURFACES. For plaster, gypsum, concrete, cement or mortar based on hydraulic binders, ensure full curing and drying
(min. 1 month for concrete and cement). All surfaces should be sound, clean, dry and free from, dirt, grease or oil. Eliminate efflorescence and mold if present. Rub down sound glossy/polished surfaces to open pore. Avoid the inhalation of dust. Rinse thoroughly to clean up any generated dust. Use repair plaster to repair any surface defects if necessary. For exterior surfaces prime with Primerlite (Prod. Code 21.702) or Akril-80 Sealer (Prod.Code 42.115). For interior surfaces use Hidrocril (Prod.Code 81.006).
Finish coating applying minimum 2 coats of Juno-Rev.
PAINTED SURFACES. If surface is sound, clean, dry and free from grease, paint can be applied directly. Remove any crazed or flaking paint. Rub down sound satin or glossy surfaces with fine abrasive paper to improve adherence and reduce surface tensions. Rinse thoroughly before proceeding as with untreated surfaces. Carry out a test patch to ensure compatibility with previously used/old paint, and to test the adherence of previous coats thus avoiding incompatibilities between old and new paint. To seal dust, improve adherence and even out and reduce absorption, apply Akril- 80 (Prod. Code 42.115) or Hidrocril (Prod. Code 81.006). In case of plastered areas prime these with Primerlite (Prod. Code 21.702). Finish coating applying minimum 2 coats of Juno-Rev.
PLASTER AND GYPSUM. Interior only. Clean and leave to dry completely. Seal absorbent surface with Hidrocril (Prod. Code 81.006)
and finish by applying two coats of Juno-Rev.
PROJECTED PLASTER. Interior only. Given large differences in absorption of such surfaces for this type of substrates, we recommend sealing surface with Aquasell (Prod. Code 21.203).
PATHOLOGIES
Mould contamination. Wash thoroughly and disinfect using Junoclean (Prod. Code 760.180)
INDOOR-OUTDOOR
Recommended for the protection and decoration of mineral surfaces (façades of cement, concrete, separation walls, patios etc.)
where maximum resistance to atmospheric agents, humidity, proliferation of microorganisms and to the carbonation of concrete is required.
Ideal for coating renders, pebbledash and any difficult surfaces by spraying or rolling.
Stir paint well before use, ensuring complete homogenization.
Apply on consistent, clean, completely dry surfaces, free of efflorescence (saltpeter) and mould.
Paint applied onto gloss, satin or elastomeric surface may lead to micro-cracks.
Dilute paint depending on the porosity and condition of the surface.
AMBIENT CONDITIONS. Do not apply on substrates with temperature lower than 5°C or excessively heated surfaces.
The temperature of the substrate must be at least 3°C above the dew point. Relative humidity level should not exceed 80%.
APPLICATION METHOD. Brush, roller or spray equipment.